3d scanning in Newport

Yes. From the board, component or task, we design and produce jigs and fixtures to hold, locate and support parts for assembly, test and inspection. For a Newport electronics manufacturer it means bespoke tooling made to a specific product and process, produced and revised quickly, so assembly and test are accurate and repeatable rather than relying on hand-holding parts or adapting something not quite suited.

Yes. We design and produce bespoke enclosures and housings for a device, instrument or piece of equipment, or reverse engineer an existing one to modify. For a Newport manufacturer it means a housing made exactly to a product, whether for a prototype, a low volume or a one-off instrument, produced quickly, which off-the-shelf enclosures rarely fit when a device does something particular.

Often, for non-critical parts on production or test equipment: guards, covers, brackets, holders and housings. We scan the worn part and reproduce it, or supply files. For a Newport manufacturer it keeps valuable production or test equipment running when a non-critical part fails and the maker no longer supplies it, rather than facing downtime or a costly replacement over a small fitting.

Yes. We scan a part or assembly and compare it to its CAD, producing a deviation map, useful where accuracy and fit matter. For a Newport electronics firm it gives clear evidence a part, enclosure or mechanical component is right, so it can be signed off or corrected on measured fact, which matters when tight tolerances and repeatable fit affect how a product goes together and performs.

Yes. We prototype a part or enclosure and produce small numbers, so a product can be tried and made in low volume before or instead of committing to hard tooling. For a Newport manufacturer it suits new products, short runs and instruments made in small numbers, getting real parts made quickly and affordably without the cost of tooling that only pays off at high volume.

Always. There is no minimum order, so one fixture, enclosure, part or inspection is a normal job. Send a drawing, a sample or the part, and we will price it clearly, usually the same day, with a typical 3 to 5 working day turnaround once we have or have scanned it.

Tooling, fixtures and production parts digitised for quality control and replacement.