3d scanning in Gloucestershire

Yes. From a component, an assembly or a design, we make assembly jigs, drill jigs and locating fixtures for aerostructures, from accurate CAD or a scan. For a Gloucestershire aerospace maker it means bespoke tooling made to hold and locate a structure precisely, produced and revised quickly, so a build is accurate and repeatable rather than relying on slow-to-source tooling, within our non-critical remit.

Yes. We scan an assembly or structure and compare it to its CAD, and make gauges and check fixtures to verify key geometry. For a Gloucestershire aerospace firm it gives a fast, repeatable way to confirm an aerostructure or an assembly is right, and clear evidence on measured fact, which matters where fit and tolerance on a structure are tightly controlled and must be proven.

Anything flight-critical or safety-critical, parts whose failure would put an aircraft at risk, goes through the proper certified route, and we do not make those. We handle jigs, fixtures, gauges, non-critical parts and inspection. For a Gloucestershire aerospace maker it means fast help with the tooling and inspection side, with a clear line on what certified aerospace engineering must own.

Yes. We scan a worn jig, fixture or non-critical part and rebuild it as CAD, so it can be reproduced. For a Gloucestershire aerospace supplier it recreates tooling and parts no longer supplied, common on long programmes, so a build is not held up because a specific jig or part cannot be bought, with hardened or flight parts made by the proper route.

Yes. Our scanners are portable, so we travel across Gloucestershire to capture a structure, an assembly or tooling too large or fixed to move, at an aerospace works. For a Gloucestershire maker it means a large aerostructure or a fixture can be scanned where it is, then tooling or inspection worked up at our Essex workshop, while smaller parts are handled by post.

Always. There is no minimum order, so one jig, fixture, gauge or inspection is a normal job, whether for a large Gloucestershire aerospace maker or a supplier. Send the part or details, and we will price it clearly, usually the same day, within our non-critical remit.

Tooling, fixtures and production parts digitised for quality control and replacement.